openRow Mantis
Live Dashboard
disconnected
Service UUID Char UUID ← Back to Version Selector
⚠ Web Bluetooth is not supported in this browser. Please use Chrome on desktop or Android. Safari and Firefox do not support Web Bluetooth.
How to use the dashboard
  1. Open the dashboard. Use the openRow app on iPad, or Chrome on desktop / Android. Safari and Firefox cannot connect to the receiver directly.
  2. Power on the RX unit and make sure its OLED shows the receiver is running. The TX unit should be on too, so there's actual data flowing.
  3. Hit Connect (top right). Allow Bluetooth access, then pick openRow_RX from the device list. The status dot turns green when it's connected. If access was denied on iPad, enable it in Settings → Privacy & Security → Bluetooth.
  4. Watch the numbers. The Acceleration card shows the live resultant value, Device Uptime shows how long the TX has been running, and the graph plots acceleration over time as the boat moves.
  5. Save your data with Export CSV or TXT. In the iPad app, exports are saved in Files → On My iPad → openRow → Sessions, and a share sheet opens. Keep the app visible while recording; export before closing it.
If the device doesn't show up in the pop-up, double-check the RX unit is powered, the antenna is on, and you're not already connected from another tab. The two UUID fields above (Service UUID and Char UUID) are pre-filled to match the firmware — you only need to touch those if you've changed the UUIDs in RXmain.cpp.
Acceleration
--
m/s² resultant
Device Uptime
--
ms since boot  ·  -- Hz
Acceleration / Time
-- m/s²
No device data yet
Raw Data Log